Ha guys I have stumbled across a inter-cooler the inlet and outlet are on the same side so would make more plumbing if front mounted so was thinking of top mounting has anyone done this.

I was thinking of something like this, moving the air box to the side and then the turbo cross over pipe would be gone thus allowing for a lower fit, and less plumbing than out the front, suggestions please.

Attached Images

	IMG_5474.jpg (49.9 KB, 43 views)
	IMG_5473.jpg (33.3 KB, 31 views)

where will the air go when it passes through the cooler? isnt there too much restriction with the motor there?

it's just sitting there as an idea not it's final mounting place, it would need a bonnet scoop to allow air flow and mount it a little higher but top mounts aren't that high off engines really due to room, patrol and subaru wrx that I have seen are pretty close and not that big either, just looking at it for the moment as I can get it cheap.

One of the members (dylan gover) has a small top mount intercooler setup in his perentie. He's posted some pics on isuzurover's budget turbo install thread, links below

http://www.aulro.com/afvb/isuzu-land...install-4.html - top mount intercooler

http://www.aulro.com/afvb/isuzu-land...install-6.html - bonnet scoop

Perhaps send him a PM?

__________________
1986 90 Commercial, 3.9L V8i... F+R MD's, 4:11 centres, 35's and a few other goodies on the way
1984 120 3.9Tdi, LT95, F+R MD lockers, LT95a & perentie PTO / winch in the garage
1984 V8 County - cannibalised for parts