Hey Matt... Your gona but a grader blade in the rear of this thing You may need 37's

__________________
:Strange Rovers Down Under 4BD1T 120" 110 /3 Rangies:/ 3 series 1's/ 2 series 2's/2 series 3 88's/2
series 3 109's and a heap of rice burners

Well, nearly 27,oookays on, trouble free

Well the box jumps out of 3rd on light overun, I'll change it one day

__________________
"There is a good idea in the bottom of every bottle"....Jack Daniels

Some very hard ks in those I would imagine

__________________
:Strange Rovers Down Under 4BD1T 120" 110 /3 Rangies:/ 3 series 1's/ 2 series 2's/2 series 3 88's/2
series 3 109's and a heap of rice burners

Oh yea, it gets, umm, driven

__________________
"There is a good idea in the bottom of every bottle"....Jack Daniels

The LT 95 in my old 4.4 2 Door pops out of third on overrun as well... I can't be bothered going in until something makes a real bad noise in there

I suspect its only a bit of end float causing mine to do it.

It'll go for years as hasn't got a 3.9 ltr rattle gun on the end of it like yours has

__________________
:Strange Rovers Down Under 4BD1T 120" 110 /3 Rangies:/ 3 series 1's/ 2 series 2's/2 series 3 88's/2
series 3 109's and a heap of rice burners

Was rebuilt by an engineer ya see

Has done it since I put it in, pulled out of a wreck, that the dude had rebuilt the box in, I'll just slap another goodin in that I have laying around....one day

__________________
"There is a good idea in the bottom of every bottle"....Jack Daniels

Grave dig for intercooling.

How big a core did you fit in there and how did you get the the pipes through?

Exchange for wheelspin vids

Pipes run through under radiator......you need body lift

Core was the largest I could fit in the area, had to also remove centre braces and remake cross support

__________________
"There is a good idea in the bottom of every bottle"....Jack Daniels

Bugger, no body lift.

wheelspin dougs, wheelspin