Been on back load for a while. Has finally arrived at home.

Firewall is not the best. Chassis ok, seem to be only surface rust.

Brake and clutch US. Brake lines will need to be replaced.

Was DPC, nice coat of house paint over it.

Came with what’s left of the rear canvas. So any one need a template, pm me.



112-158 1091961. Series 2 c6043B 1511124791 53100850--NSW.

6043B, Automotive Repair Shop, Truck mounted, 3/4 ton, GS, With Winch, Garage.

Rear/platform body number 59. 2/62.



























Shes rough but should come up ok.

Cheers

Richard

__________________


Its a great day to be an Aussie.

not bad, have you run out of room yet.
that other one i discussed with you ( the parts veh) i think is the same model,


john

__________________
North Coast NSW
96 Discovery 300TDI auto
project 78 HZ 308 wagon aka \'The batmobile\' its going!!
1978 ser FFR the new project
REMLR 253
Got 2 SWB ser 3 now and lots of bits!!
back from the desert for the moment

Good one Richard
When are we going to fire it up?
Maurice

Good job looks like lots of potential there.

__________________
Current - Elsa the lightweight
Current - 1950 80 inch hardtop
ex - 1997 Disco tdi
ex - series 3 109 (diesel)

REMLR member no. 144

G'day 69gs

Looks pretty straight Richard, and quite complete for it's age, do the engine no's match, and how startable is the motor, any water in the oil, what's the Radiator like, all in all , looks like a good mate for Lousie It would have started life as Deep Bronze Green, with full front guards, and modified later and repainted O/Drab

cheers

__________________
68 2a GS 6028D 172-484
Aust No5 trailer 2wheel 1/2 ton Ch 1974=173-489
REMLR No 003

The termite prevailed ! Cheers Muddy!

The motor is a goer. 13/14 years since last fire up.

Firewall is terminal (Me thinks). Chassis only needs a small patch plated at rear, 50x50 mil.

Is still set up with a positive earth, electrical system.











Cheers,


Richard

__________________


Its a great day to be an Aussie.

G'day 69gs

I hope that you changed the oil BEFORE you stirred up that crud in the sump, and splashed all that acidic oil around that firewall looks OK to me, just a little bit of rust on the Left side, mine was worse than that on the right side, I just handmade plates then welded them in out of 2mm steel,and salvaged the pillar sections from another old rolled firewall but those sections are available now as rust repair section, both here and from O/seas ( better quality) and then you can replace the dead sections, the inside sections can be excised and trimmed with a die grinder and repaired

cheers

__________________
68 2a GS 6028D 172-484
Aust No5 trailer 2wheel 1/2 ton Ch 1974=173-489
REMLR No 003

G,day Mate,so you got the old girl home hey!.looks good,many more hours of fun.just looked at your list of vehicles,crikey!.i think you have more than me now.114-105 should be of to the sandblaster next week,about time to!.

Hey MC,

Yep about time hey.. Few more hours needed than Louise.

__________________


Its a great day to be an Aussie.

Hi 69gs
you will have to add the ones at agistment to your portfolio LOL