I've looked at a lot of lights and there's not many that will fit 3 in the space I've got to work with.
This is the size of the area the lights have to fit in........
https://www.aulro.com/afvb/images/im...12/05/1086.jpg
Printable View
I've looked at a lot of lights and there's not many that will fit 3 in the space I've got to work with.
This is the size of the area the lights have to fit in........
https://www.aulro.com/afvb/images/im...12/05/1086.jpg
Hi Murray,
Does the new dual carrier bar fit the back of a 130 with the standard tub and still allow the tailgate to fold down all the way or will it stick out too far?
Regards,
Scott
G'day Scott,Quote:
Originally Posted by scottvdw
Unfortunately the dual carrier, as with the single carrier, wont fit the 130 because of the overhang of the tub or tray. The single carrier I make for the 130 is a completely different design to the 110-90, so the same would have to be done with a 130 dual carrier.
Cheers, Murray
Hi Murray,
Great work !!
If you haven't already thought about it, paranoid people like myself would want a locking device for the Jerries.
Regards,
David
Hi DeeJay,Quote:
Originally Posted by DeeJay
There are extra holes at the top of the jerry holders through which you could use a cable and padlock. At this stage I haven't thought any further than that, but it wouldn't be too difficult to retrofit a hinged panel that goes right over the top of the fillers, preventing theft of either the jerry or the contents.
A similar idea to this, only over both cans.
https://www.aulro.com/afvb/images/im...12/05/1074.jpg
Cheers, Murray
Murray
Have you considered a double Jerry carrier like on the RSV Perentie 110? The cargo door can be opened without moving the jerry carrier.
My rear cross member (Perentie) is a bit like your addition with lights mounted lower.
https://www.aulro.com/afvb/images/im...12/05/1041.jpg
I haven't considered it, but anything is possible.Quote:
Originally Posted by rar110
One thing I have considered with the swing out jerry arm is a table that hooks onto the back of it in the open position.
Cheers, Murray
Well Murray , I want you to make a storage bin with lockable door to go at the bottom of the rear quarter panel .
Like these Terrafirma - Land Rover TF887
And a air vent for the pass side front panel to extract heat from under the bonnet ....my wish lists anyway :D
Between work and preparing for a trip things have been a bit crazy around here, but I managed to get the prototype rear bar finished.
We leave for Cape York this Friday, so the bar and carriers will get a good workout over the next four weeks........can't wait to hit the road.
Cheers, Murray
https://www.aulro.com/afvb/images/im...012/09/550.jpg
https://www.aulro.com/afvb/images/im...012/09/551.jpg
Murray might see you on the road as we leave next Sat for the cape :)