Water Filter Trap

There deffinatly is a water sensor kit to fit the clear bowl. The part number of the bowl kit is as stated earlier 29899. The water sensor kit that fits this bowls part number is 29268 both are Stanadyne parts.
I have aquire both, however I still need to fabricate one of Tim plates. Thanks for the excellent drawing Tim will save me a lot of time.
The sensor kit includes the probe and adaptor for the bottom of the bowl, and an indicator light unit plus a long harness. Which may or may not need to be extended. Hope to find that out soon, maybe this weekend.

Regards
Dungie

Also my compliments to Tim for the useful plate drawing!

Two question:
Could you please confirm that the bowl is fully compatible with the standard LR filter ?

This Stanadyne filter is fully compatible with the standard Puma 2.4 LR filter ?
https://www.aulro.com/afvb/images/im...12/11/1366.jpg

Thanks!

Mario,
I have not yet fitted the bowl onto the genuine filter. However by the look of Tims photos,and the cross reference of the Stanadyne filter it will fit.
I have not looked into the micron size of the Stanadyne filter as yet, will be staying with the L/R filter at least until my warranty is out.
Regards
Dungie

Thanks for your reply.

The Stanadyne filer is 5 micron, the same as the standard unit.
I agree with you, if the Defender is under warranty it's better to fit the original filter to avoid warranty problems.

When out of warranty, the Stanadyne filter is cheaper than the original filter, could be a good alternative.

@TimNZ

Hi, I replicated the plate to relocate the filter mount from the drawing you kindly posted.
Really great work, but I think there is one little error with the lowe left two holes.
From the drawing all the lower holes are levelled, but wouldn´t fit that way (at least to my 2.2 Puma).
The lower left holes should be a couple of mm´s further up - just like can be seen on the picture shot of the real plate.

Quote:

---

Originally Posted by landybehr

@TimNZ

Hi, I replicated the plate to relocate the filter mount from the drawing you kindly posted.
Really great work, but I think there is one little error with the lowe left two holes.
From the drawing all the lower holes are levelled, but wouldn´t fit that way (at least to my 2.2 Puma).
The lower left holes should be a couple of mm´s further up - just like can be seen on the picture shot of the real plate.

---

Care to extrapolate?

I'm just about to knock one of these plates up and it would be nice to know how much to relocate any holes by.

Edit: looks like you have changed the original drawing to account for this Tim?

Tim has updated the drawing [thumbsupbig]

When you put the filter mounting base bracket/plate onto the adapter as kind of a template (you have to remove it temporarily anyway) itbecomes obvious if one hole issn´t aligned.

Anyone manager to get the Stanadyne filter/water bowl/alarm online anywhere?

Local dealer isn't interested in ordering it in for me.

Cheers.

Hi Mate,

Not a online merchant, but Stanadyne's dealer map. At least one of them should have an online function...?

Stanadyne Dealer Locations

or these guys (who are an online merchant) show Stanadyne as one of their products.

Products - Diesel Care - 4WD Dyno Tuning, Bosch Diesel Centre, Diesel Engine Enhancements, Fuel Injection, Turbochargers, Steinbauer Power Module, Service & Exchange

Cheers,

Lou

Cheers Loubrey - just ordered a filter, water bowl and sensor kit from Diesel Distributors.

On that note though, they advised me that the correct filter part no. is 33960 and NOT 36995 (which is too short?) - anyone using a 36995 (or 33960) care to comment/confirm?