Thought I might be pushing my luck. I ordered a new set from rover parts today, only because I just put super pro bushes in about 3 months ago and I wanna get this done - hopefully I haven't flogged out the bush tubes already..? I thought the MR Auto boys woulda mentioned the bolts being flogged when they pressed in the bushings on the A frame... I haven't pulled the bolts yet to confirm so maybe it's not even the case though I'm guessing it is.Quote:
Originally Posted by rick130
Hopefully the brackets themselves aren't eyed out too. They are a fair bit more expensive than a $10 set of bolts from roverparts.
I checked out the unbrako website, they make some nice stuff, you don't generally associate "made in India" with quality but these guys looked legit. I'm thinking I might get some turned in the near future, get some made to perfect tolerance for the superpro - it's all I'll use from here out anyways and if the tolerances and shank length were spot on might be a one time job - well with that and the adjustable a frame they'll probably outlive me. im guessing superpro would have the available measurements for the inner tube I.D and getting the bracket width for shaft length is easy enough... Worst case I'd have to bust out the vernier calipers I guess..
For now though I guess I'll pull the bolts and while I'm there I'll replace them anyways, check the brackets and the bushes too.
Wish me luck.
