Printable View
Quote:
Originally Posted by jboot51
Yes I have gathered as much after talking with various "land rover experts". It should have tweaked when I saw the filler plug missing!!
Anyway, would the order of events be 1. Crossmember remove, 2. Transfer case remove, 3. Floor remove 4 Gearbox remove ??
Quote:
Originally Posted by jboot51
It is pouring straight out of the slot as can be seen in the pic below
Quote:
Originally Posted by DizzyLimit
that looks like your wading plug, nothing to worry about
more than likely its the input shaft seal leaking if it coming out if that hole
Ok Thanks for the reply. Makes me feel a little better but I am fully expecting the worst. I will pull out the box/transfer and as others have suggested address any other issues while I am at it, clean everything, get the box checked for issues (if possible) and reassemble with new input seal. I will allow 2 weeks of hard work and raised tempers. I will document the process for all to see. Cheers.Quote:
Originally Posted by Duarte19
Do you have a shed to work in. (air conditioned would be nice)
If so, I don't have a lot of free time but might be able to lend a hand.
I can borrow an engine crane short term.
Quote:
Originally Posted by jboot51
Thank you for offering JBoot51, you are a champion, should be more like you but there has been a development... I have to say I feel like an idiot but all is good, it would seem that the timing port hole on the BELLHOUSING!! is not the best place to try and pour gearbox oil into. Yes I discovered this after doing what I should have done in the first place and checked out the procedure on YT. I took it round the block again yesterday, got everything to operating temp and drained diffs, box and transfer- and boy did they need it. But lets stay in touch I am down the coat often and will call in and show you the Beast! Cheers :wasntme:
Good to see you got it sorted.
You learn something new everyday.
Thats a wading plug. It may also be a rear main seal. Can you determine if it is gearbox oil or engine oil? The drip looks a little dark to be trans oil.
If you dont have a Rave manual get one as it helps a lot. If you need it urgently let us know and I will see if I can print out and scan the sections you need and email. Sorry assuming TD5 but should not be much different.
There is a specific sequence, but a lot of stuff can be done in any order.
Air box will need to be removed so you can get to the top bellhoousng bolts,
Remove tails shafts.
Remove centre pipe exhaust and front pipe.
Remove cross member.
Remove gear sticks.
Remove console and floor panel underneath.
Remove tunnel.
Disconnect all elec plugs to box and Crank Angle sensor to bellhousing.
Remove handbrake cable.
Remove starter motor.
Unbolt earth points on gearbox and trans case.
Remove clutch slave cylinder.
Disconnect linkages between gearbox and trans case.
Sling trans case to engine crane.
Undo and remove drivers side trans case mount and remove taking up weight on trans case.
Unbolt trans case from gearbox.
Slide trans case back and lower to floor.
Once done set up crane and slings to gear box.
Unbolt bellhousing bolts and take up weight. Slide gearbox back an lower.
You may need to jack up the car to get boxes out from underneath.
This is just from memory.
Can be done in about 1/2 day easily at a reasonable pace. About same to put back in.
I had the same panic attack (see previous threads with photo in this forum) a few years ago.. The only difference is that I didn't try and put any oil in.Quote:
Originally Posted by DizzyLimit