Printable View
Mine is the factory single cab ute set up. Not sure on the exmoor trim seat but the land rover one is a tubeular steel frame, non adjustable, with a lift out cussion same as the other front seats only a bit skinnier. When you sit the seat frame in position it is obvious where it bolts to, basically straight down through the seat box. Your exmoor seat should have fitting instructions, if not contact seller.Quote:
Originally Posted by sjl81
If I were to fit an Exmoor Trim centre seat for the sole purpose of carrying my small dog in a Defender 90 would there be any requirements for engineering? - if so he's in the back. I find him a very useful warm armrest in the Series 1's.
Also for Puma installations Exmoor note: "that the best solution when fitting to a puma is to mount the seat slightly back to give some suitable clearance to the gear shift, this is easier in a 110" or a 90" without a bulkhead."
I have a ser3 88 3 seater. An old school child seat hook was mounted on the on the base on the spare tyre bracket.
My son is 5 so he uses the new modern booster seat. Has to move his right lower leg for 2nd gear. however in the harness he can reach the gear stick to do the shift. to get low range you have to lean on the passenger.
have a 2 person rear seat out of a county for the right and are looking for a single [FFR] and some factory set belts to suit.