Have a look at this Mick, looks pretty simple.
Cheers.
DEFENDER2.NET - View topic - Bonnet stay plastic clip! (How to)
BTW thanks for the post, reminds me I should carry a spare
Have a look at this Mick, looks pretty simple.
Cheers.
DEFENDER2.NET - View topic - Bonnet stay plastic clip! (How to)
BTW thanks for the post, reminds me I should carry a spare
Paul.
77 series3 (sold)
95 300Tdi Ute (sold)
2003 XTREME Td5
I thought I was wrong once, but I was mistaken.
Thanks all. Good spot. Now fixed. The base part had to be separated and turned up the other way. Duh!
I still don't trust it though.
Sound proofing sux!!
I have had one break on me, well it snagged whilst working under the hood, it around $15 from JLR.
This is a better aftermarket design.
LAND ROVER DEFENDER 90 110 130 BONNET PROP STAY CLIP - PRC3180 | eBay
Also can you share a photo how yours looks installed if you don't mind? I don't remember swapping ends, just cut and shave the bottom piece and shove the top one into it for a flush fitting
pd
Hope I finally got it right.
I pulled the bottom off, pushed it up through the hole as far as it would go, then pushed the shaft of the top down into the hole.
I'm a bit embarrassed I didn't realise the bottom separated. After mine disappeared I couldn't remember how it had looked. It's one of those things you ignore until it breaks.
Replaced P gasket
Replaced power steering pump
Replaced front and rear output flages and seals on transfer case.
Still more to do
Search AULRO.com ONLY! |
Search All the Web! |
---|
|
|
Bookmarks