Printable View
No too tight,Quote:
Originally Posted by cal415
Options
Cut and weld the bulkhead and floor
Weld some 3 inch crush tube run through the front outrigger and run it through that.
Cut off the exhaust at the front guard
Car will be at Lokka's Friday night, go have a look. Your welcome to suggest solutions.
I think its time you posted pics of your county:)Quote:
Originally Posted by EchiDna
No need to be as drastic as all that, IME there is only a slight interference (well with 285/75-16s or 255/85-16s - don't know about 33x15s on big offset rims), that can be fixed by cutting out the offending corner, and replacing it with one with 2 bends, to bring it further away from the tyre.Quote:
Originally Posted by dobbo
e.g.
|
\_
(2 bends where there was only one before).
i have an isuzu county and run 35" tyres on 15x8. misses by miles. i cant even imagine where it would hit?
can you take a picture?
Passenger side front guard, standard 31inch tyres miss the exhaust by 30mm, therefore fitting my 33's will fowl the exhaust.
mines inside the chassis rails all the way to the back. goes into the LHR wheelarch though.
Quote:
Originally Posted by mitch
Any pictures from the engine bay and under the car?
Have you had to cut the bulkhead to make that fit. Not a lot of room in the engine bay for the pipe to run.
i will take some in the light tomorrow for you. mine is a turbo 4BD1 but i doubt that will make much difference.
*Cough*:eek:Quote:
Originally Posted by mitch
*sigh*Quote:
Originally Posted by rovercare
you're not wrong, but it's in Melbourne in storage and I'm not!