TDCi Defender Accessory thread

Gday all , well let me see

2" suspension lift

fog lights

roof console

rust prof

rear wheel carrier

in car safe

double carden joints

scorpion racing rock/tree sliders

diff guard

satelite navagation garmin c130

laptop running oziexplorer

Hema navigator

inverter for chargeing batterys

pda running oziexplore cv & bluetooth gps receiver

OL winch bar

9000 lb winch

HID spot lights one spot one spread

Icom radio unit 9 db and 6 db

two hand held uhf gme radios

arb fridge and insulated cover

brown davis fridge slide

snorkel

arb roof rack

arb seat covers

arb air compressor (tyre inflation kit)

staun tyre deflators

window tint

custom fishing rod holders

shovel holders on roof rack

full recovery kit

private number plates

rock sliders

mickey thomson mtz 265/75r16

black sunnys

rear storage system

anderson plug to rear

high lift jack attached to rear bar

made a new shovel holder that goes on the spare

arb awning

pioneer arglie 4x4 hard floor camper trailer


cheers
chaser

still more to come when SWMBO lets me

since when was a center diff lock an accessorie on a defender :Rolling:

only kidding mate you have a great set up one many would be jealous of :)

Mantec Snorkel kit - can't fit it until I get the Checker Plate :)

https://www.aulro.com/afvb/images/im...2008/09/65.jpghttps://www.aulro.com/afvb/images/im...2008/09/66.jpg

Quote:

---

Originally Posted by dm_td5

Mantec Snorkel kit - can't fit it until I get the Checker Plate :)

---

Mate I must be having an off day but can you elaborate why you cannot fit the snorkel before the chequer plate kit? I cannot see how the two can interfere, is it due to the fitting procedure of the new Mantec snorkel?

Seeing as this is the tdci accessory thread, can we get some photos posted of said accessories .. to give the rest of us something to drool over? :)

the snorkel stops you getting to some of the rivet holes in the chequer plate, other wise think it can be fitted.

Installed the UHF radio on the weekend. Main unit is under the cubby box which I raised by about 20mm.
There is already a hole under the cubby box for the aerial cable.

Regards

John D - Defender 110 2.4

Quote:

---

Originally Posted by jddisco200tdi

Installed the UHF radio on the weekend. Main unit is under the cubby box which I raised by about 20mm.
There is already a hole under the cubby box for the aerial cable.

---

Make sure you have a rubber shim between the aerial bracket and the top of the grille panel. There's quite a bit of friction there when driving over rough roads so the exposed painted top will get worn. I used sticky-back black rubber, only 2-3mm thick or so.

Quote:

---

Originally Posted by muddymech

the snorkel stops you getting to some of the rivet holes in the chequer plate, other wise think it can be fitted.

---

From memory dm_td5 is getting an OEM chequer plate kit. They don't extend to the rear of the wingtop, it should not interfere getting to the rivet holes.

http://img89.imageshack.us/img89/2611/dsc0474pttw6.jpg

our chequer plate kit had to be drilled to encompass the areial.......not oem but ours goes all the way doesn't stop where yours does

The pre-07 Defender OEM kit goes all the way to the back but the new kit stops short of the aerial .. as per Scallops' vehicle above.