Thread: defender vents

Assuming they are the same as the older ones, the hinge pin is knocked out with a suitable drift - I made one by cutting the point off a four inch nail - and the two small hex head screws that attach it to the vent can then be removed (open the vent). Don't drop them into the dash - you may have a major job to recover them.

The whole operation is done from outside, something to stand on makes it easier.

John

thanks John,
I managed to remoe it Ok (8mm spanner) and have replace the one seal NOT muc fun putting it back on
Mal

Also taking off the bonnet gives you a little more room.


Ben......