need info on how to fit this bull bar on my 96 p38

[russtypipes]

like the title says need help fitting this bull bar to my 96 4.0se p38.
Do i need to enlarge any holes or make new holes?
has anyone else fitted this? Thanx :confused:

[V8Ian]

That's a stock ARB bar, if it's made for your model it will bolt straight on.

[BigJon]

That is a stock Disco bar, not a P38 bar. Mods will be required. I have seen pics of it done but I don't know exactly what is required. Someone here will know...

[p38arover]

Andrew e has modded one to fit a P38A

[banjo]

IT GOES ON THE FRONT does that help

[russtypipes]

ARB Land Rover Discovery Series II (2003-2004) Winch Bar Front Bumper (3432120)

yes i know its not for my 96 RR 4.0 P38. but i know its been done. just need to know exactly what mods need to be done... i dont wanna **** it up... thats y im asking figured someone here would know. thanx for your time. much appreciated. :confused:

[russtypipes]

"You can make D2 bars fit (ARB anyway)
the chassis rails are at same spacing the only thing you need to do is mod the 2 bullbar mounting brackets (cut the top out them and redrill) to lower the bar slightly as it hits the panelwork if fitted at std (D2) hight"
Jase


thanx

[DT-P38]

Hi, That sounds interesting and no doubt a few of them (plenty more disco's than p38's) pop onto the "used bar" market irregularly... can you please take a few snaps for those of us who like sniffing out a bargain or two?!? :cool:

[Remy]

http://www.aulro.com/afvb/p38a-range-rover/90900-new-release-arb-p38-winch-bar.html