a-pillar trim removal

[dagz]

I have a disco 2 and was wondering if anyone knows how or are there instructions anywhere here on how to remove the a-pillar interior trim panel with the speaker in it, so that i can route some power and antennae cables for a cb unit i am about to install.....thanx :confused:

[Slunnie]

Just grab it and pull.

[dagz]

thanks i will give it a go. sounds too simple but as i am finding out with my discovery, they are good to work on.

thanks

[Bundalene]

Remove the plastic studs on the inside first, put your fingers under the windscreen seal bit of the trim and then as Slunnie says.

Erich

[dagz]

Cheers Slunnie and Bundalene.
All went well, the cb unit is in and yor advice was sound. Just pull and away she comes.
All back together and not a scratch.

Thanks again.[thumbsupbig]