Front springs

[coolblues_au]

Our 02 110 appears to be sagged in the front. We are intending getting a winch soon and that would no doubt make it worse. What is the best option for this fix. I guess it needs around 50mm. Do we go for Landrover springs or what ?

[kram]

Our 02 110 appears to be sagged in the front. We are intending getting a winch soon and that would no doubt make it worse. What is the best option for this fix. I guess it needs around 50mm. Do we go for Landrover springs or what ?

I had the same problem with my 97 110. I ended up putting in King Springs 'raised height' (about 30mm) in the front to level out the front and account for the extra weight of the front bar etc etc. I have found no problems at all with ride and in fact it reduces body roll around corners. I got them from Rovacraft in Bayswater VIC.

Easy to install - but my tip is to use coil spring compressors ($40 from supercheap) - makes the job about 30min less per wheel:)

Mark

[land864]

Smae prob here on our 02 110 with winch and bar.

I think I read on here that the GO is to use 130 HD springs.

Cost approx $ 140 each OE supply?

Hey Kram , how long did it take you all up?

[Xtreme]

The specified HD spring for the 110 is the same as the std front 130 spring and is the way to go for the 110.
I have done this on three 110's that I have owned and have found that, apart from also adding Polyairs to the rear and decent shocks all round, there is nothing else that the 110 suspension needs.
I usually pay less than $150 for the pair of front HD springs. I can't recall the part numbers off hand but the passenger and driver side are different.

[land864]

Aahh , so it's a pair of HD110 fronts or standard 130 fronts.

$ 150 for the pair or $ 75 each:)

[coolblues_au]

I am hearing you guys, thanks.

[rick130]

If you want a little higher lift with a similar spring rate, LRA 'purple' springs are 17" free length and 220lb/in which will give a 130 with a bullbar/winch around 117mm between the bumpstops when new.