svx snatch/tow points.

[portafilter]

Hi all I was at the defer meet up a few weeks back and spied a nice svx with two bolt on plates, with d shackles hanging off them, bolted to the chassis rails just under the bumper. Looked like a very good solution to front recovery points!
Anyone know where to get them?
Justin.

[portafilter]

a photo, everyone loves a photo!https://www.aulro.com/afvb/

[sniegy]

Try PM'ing Tombie. He may be able to help.
If not try emailing Simon at questions@4x4intelligence.com.au (questions@4x4intelligence.com.au)
or look his website www.4x4intelligence.com.au (http://www.4x4intelligence.com.au)

HTH

Cheers

[SVX37]

Hi Justin,

That is mine.

I got them from here...
http://www.range-rov.com.au/images/logo.JPG?854
187 Rooks Rd, VERMONT, VIC, 3133
Ph: (03) 9874-3111 Fax: (03) 9874-2133
Very happy with them.

Nigel

[Allan]

a photo, everyone loves a photo!http://www.aulro.com/afvb/attachment.php?attachmentid=27984&stc=1&d=1282359738


Hi portafilter, did you get the wiring diagrams I sent you? If not I can try again if needed. Sorry, meant to make this a private message, brain freeze.

Allan

[portafilter]

Finally got around to fitting these this week. the snatch points were a bit of a pain but should be rock solid, two 12mm bolts through the jack point assy that is welded to the chassis rail. while i was at it a took a bit of advice off this site and fitted a fuel tank breather filter and shifted the inlet point away from the wheel spray. about 300mm of 8mm fuel line and a small clear inline filter from Repco. the white tube you can also see is the relocated diff breather now going up into the space behind the number plate.
all good for a couple of hours work.
http://www.aulro.com/afvb/attachment.php?attachmentid=28908&stc=1&d=1284777439
http://www.aulro.com/afvb/images/attach/jpg.gif