Pedro_The_Swift
1st December 2010, 07:21 AM
This by the good graces of Bundalene:BigThumb:
Removal of the rear D2 Drinks holder.
First remove the facia
https://www.aulro.com/afvb/ (http://img716.imageshack.us/i/dscn0493j.jpg/)
This is simply done by prising it off. The facia is retained at each end by a plastic lug as shown below.
https://www.aulro.com/afvb/ (http://img541.imageshack.us/i/dscn0496i.jpg/)
Next remove the whole cassette again by prising this out.
https://www.aulro.com/afvb/ (http://img560.imageshack.us/i/dscn0525r.jpg/)
There is a metal retaining clip at each side as per the pic below
https://www.aulro.com/afvb/ (http://img823.imageshack.us/i/dscn0526.jpg/)
To remove the drinks holder from the cassette, open it in the correct way up position and then gently lever out the plastic retaining lug to get it most of the way out.
https://www.aulro.com/afvb/ (http://img641.imageshack.us/i/dscn0501e.jpg/)
Finally lift the end to allow the yellow plastic gear wheel past the opening. Be careful not to turn the holder upside down or the spring will fall out
Yellow gear
https://www.aulro.com/afvb/ (http://img826.imageshack.us/i/dscn0532q.jpg/)
Position of spring
https://www.aulro.com/afvb/ (http://img535.imageshack.us/i/dscn0531i.jpg/)
Erich
https://www.aulro.com/afvb/images/imported/2012/09/1339.jpg https://www.aulro.com/afvb/images/imported/2016/05/668.jpg (http://www.aulro.com/afvb/editpost.php'do=editpost&p=1379115)
Removal of the rear D2 Drinks holder.
First remove the facia
https://www.aulro.com/afvb/ (http://img716.imageshack.us/i/dscn0493j.jpg/)
This is simply done by prising it off. The facia is retained at each end by a plastic lug as shown below.
https://www.aulro.com/afvb/ (http://img541.imageshack.us/i/dscn0496i.jpg/)
Next remove the whole cassette again by prising this out.
https://www.aulro.com/afvb/ (http://img560.imageshack.us/i/dscn0525r.jpg/)
There is a metal retaining clip at each side as per the pic below
https://www.aulro.com/afvb/ (http://img823.imageshack.us/i/dscn0526.jpg/)
To remove the drinks holder from the cassette, open it in the correct way up position and then gently lever out the plastic retaining lug to get it most of the way out.
https://www.aulro.com/afvb/ (http://img641.imageshack.us/i/dscn0501e.jpg/)
Finally lift the end to allow the yellow plastic gear wheel past the opening. Be careful not to turn the holder upside down or the spring will fall out
Yellow gear
https://www.aulro.com/afvb/ (http://img826.imageshack.us/i/dscn0532q.jpg/)
Position of spring
https://www.aulro.com/afvb/ (http://img535.imageshack.us/i/dscn0531i.jpg/)
Erich
https://www.aulro.com/afvb/images/imported/2012/09/1339.jpg https://www.aulro.com/afvb/images/imported/2016/05/668.jpg (http://www.aulro.com/afvb/editpost.php'do=editpost&p=1379115)