LT95 front output housing

[steveG]

Anyone know that actual length difference between Stage1 and RRC/110 front output housing on a LT95.

I know the Stage1 housing is longer - just trying to work out how much its contributing to the rear uni-joint binding on my front propshaft (in a County 110).

Alternatively, could someone measure a RRC/110 housing and let me know the dimension so I can compare?

Steve

[Bearman]

From memory I think it is about 50mm, but cannot give an accurate figure until I get home on Friday. Maybe someone else will be able to give the correct figure before then.

[Bearman]

Steve, The 110/RR housing is 95mm and the Stage 1 is 125mm, so 30mm is the difference.

[steveG]

Thanks Brian.
Now I just have to get my maths hat on and work out how much suspension travel that equates to :wacko:
With "deburring" the edges of yoke its now rotating freely at full droop with standard shocks. Another couple of inches without binding would be nice so I could get the standard range (extended bump stops for the Isuzu takes a bit away).
If the shorter housing wont do it then I guess its different shaft/yokes to give greater than the standard 20deg yoke angle.

Steve