2006 Defender 110 - Rear Shock abosorber bushes

[Yorkshire_Jon]

Guys,
Thought Id replace the worn bushes on my rear shockies this weekend, can anyone confirm the LR part numbers.

I think they are as follows:
- Top Eye Bush - 1 x NRC5593
- Bottom Pin Bush - 2 x RNF100090L

My main concern is getting the correct pin bushes. The ones on the car at the moment are almost conical shaped (top & bottom bush) to fit in the cups on the axle. I have seen others that are just flat bits of rubber & dont want those!!

Also, for the top eye bush, can it be removed and the new one put in fairly easily without a press, otherwise anyone in Sydney with a press that would do 2 bushes for me over the weekend??


Thx
Jon

[isuzurover]

Guys,
Thought Id replace the worn bushes on my rear shockies this weekend, can anyone confirm the LR part numbers.

I think they are as follows:
- Top Eye Bush - 1 x NRC5593
- Bottom Pin Bush - 2 x RNF100090L

My main concern is getting the correct pin bushes. The ones on the car at the moment are almost conical shaped (top & bottom bush) to fit in the cups on the axle. I have seen others that are just flat bits of rubber & dont want those!!

Also, for the top eye bush, can it be removed and the new one put in fairly easily without a press, otherwise anyone in Sydney with a press that would do 2 bushes for me over the weekend??


Thx
Jon

All 110 eye bushes I have seen are two-piece and don't need a press. Not sure if the newer defenders are different? However a threaded rod and a couple of washers will do the job if one piece.

Personally, I would use super-pro poly replacements.