PDA

View Full Version : 95 Defender Ignition Switch Fell Apart



ian_gregg
12th February 2012, 07:55 PM
Stinkin hot and humid, tired and grumpy wife and 6yo, jump in the Landy and no go! No lights on the dash, no clicks, no cranking?? Grabbed the jumper leads and found a donor, no change?? Checked every fuse/connector/relay I could find, no change? Decided to have a look at the back of the ignition switch and as I was tugging on the wires the whole plastic disc with the contacts came off in my hand. At least it was then easy to bridge the right wires together and get home.

Have not yet got the barrel out to have a look at rebuilding the switch.

Has anyone else seen this?

Where do I go for a new switch if I can't fix this one?

87County
12th February 2012, 08:41 PM
Stinkin hot and humid.........

Where do I go for a new switch if I can't fix this one?

Sounds like you coped with all the problems just fine

When I've been up north I've found M R Automotive at Redcliffe (07) 3284 6688 good for parts & advice.

Sue
12th February 2012, 08:56 PM
You could try British Off Road on the sunshine coast..

British Off Road - The Land Rover spare parts specialists - Home (http://www.britishoffroad.com/)

Or Ricks at Nerang..

Rick's 4WD Centre - Land Rover, Range Rover, Land Rover Discovery, Defender, Freelander, Land Rover Mechanics, Land Rover Repairs, land rover, landrover spare parts, land rover accessories (http://www.ricks4wdcentre.com/contact.htm)

dromader driver
13th February 2012, 12:49 PM
yep have been through all that including the steering lock starting to drag/do strange things. Binned the whole lot and went to a missile switch and start button. :mad:

Davender
13th February 2012, 05:38 PM
Had this happen to me a few weeks ago, bought a new unit through Linn Rover in Perth who sourced ex East for $130 odd plus air bag freight cost of $22, installed works a treat :)

aew849
15th February 2012, 03:34 PM
Ian,

Had the back end of the 2002 130 ignition switch 'fall out', but managed to remove the lock and re-crimp. Then I had the starter position spring re-sign so now have to make sure key is re-set to ON.

Would prefer the separate switches in future!

CM