PDA

View Full Version : Filling Transfer Case



geodon
27th May 2012, 03:33 PM
The TC has its own drain plug but where is the filler?

I WAS under the impression its oil was separate from the GB as the manual specifies individual capacities rather than combined.

Not so??

JDNSW
27th May 2012, 03:50 PM
Yes, it is separate. Filler/level plug is the square ended plug on the back, just to the left of the handbrake drum.

John

geodon
27th May 2012, 05:13 PM
Thnx John.

LHS facing front? i.e. Off Side?

Blknight.aus
27th May 2012, 05:27 PM
yep, lay on your back under the vehicle looking up at the Tcase with your feet/legs under the front axle

theres a square drive bung in there, thats the fill level plug

to fill....

remove the center seat, remove the plate, remove the top access plate, remove the fill/level plug

pour oil into the rectangular hole till it comes out the fill/level plug (poor slowly if you've drained it the foot takes a minute or so to fill).

done.

geodon
27th May 2012, 05:58 PM
https://www.aulro.com/afvb/images/imported/2012/05/261.jpg

I think this is the beastie.

So! The TC is L-shaped as far as the oil reservoir is concerned. I should have used the Power of Lateral Thinking!

Blknight.aus
27th May 2012, 06:04 PM
thats him.

Seriestwo
27th May 2012, 08:49 PM
Looks too clean to be a land rover :P

Series3 GT
28th May 2012, 07:52 PM
It is very clean

mick88
28th May 2012, 07:58 PM
It musta been dry to be that clean!

geodon
29th May 2012, 07:27 AM
It's called a resto!

Are LR resto's not authentic unless I use a big trowel to apply mud & cow dung after installing the mechanical components?