D2 ARB steel winch bar - gap between bar and panels.

[Disco Muppet]

Evening all.
Just wondering what sort of gap those of you with the ARB steel winch bars have between your bars and the body panels?
I'll put some pics up tomorrow, But my gaps would be at least 2cm, but everything lines up :(
Seems to be a bit much to my way of thinking.
Does everyone have this gap? Or is there something I'm missing?
Alternatively, could I use a strip of rubber or something as a filler piece?
Any pics would be greatly appreciated.
Cheers
Muppet

[MR LR]

I dunno, last time i had a look my arm got stuck in there ;) yours sounds pretty close to me :)

Cheers
Will

[Disco Muppet]

Perhaps I should clarify, my OP was pretty poorly worded.
I mean around the base of the bar, the gap between it and the section under the grille and headlights :)

Maybe it just looks a bit skeletal because the winch cradle is empty...
Good excuse for me to buy one then! :twisted: :wasntme:

[MR LR]

Haha, yeah thats what i meant too....
Its about the same 20mm gap all round :)

Yeah ours needs a winch in it too :) if i sell my car it will get one :)

Cheers
Will

[Yorkie]

mine would be about 10-20mm along the front, the ends near the wheel arch are a little closer from a few hits. :angel: