PDA

View Full Version : SII/SIIa/SIII hardtop bolts on SI hard top?



Lotz-A-Landies
18th September 2012, 09:44 PM
Hi people

I don't have any 80" gal cappings here in Sydney and need to find 4 bolts to secure an 80" hard top to an 80" for the journey from Glenreagh to SEQ. I was hoping to use the bolts off a SII/SIIa/SIII which I should have enough here.

Does anyone know if the later ones will be long enough to do the job on an 80"?

Diana

Ozdunc
20th September 2012, 05:44 PM
Hi Diana
I don't know the lengths but you could go to a bolt shop and buy a metre of threaded hi tensile bar, some washers and nuts. Wouldn't cost much and the bar chopped into 4 would be plenty long enough.

Cheers Duncan

Lotz-A-Landies
21st September 2012, 03:31 PM
Thanks for that suggestion Duncan,

I was hoping that someone with an 80" would be able to measure and even pop one of the special bolts for the SII/SIII into the hole on the 80" capping.

Diana

Northern Lander
9th October 2012, 10:21 PM
Prob a bit late but yes the longer hard top bolts on S2 and 3's fit the 80" landies cappings, I fitted a set to one last year, just need the larger diamater washer on top to hold the hard top on.

Wardy