borg warner 4462 transfer case

[paradigm]

Hello Can anyone here help me with some measurements?
I need to know the dimensions of the transmissions input shaft and how many splines it has
also need to know the input shaft dimensions for a LT230
can anyone help me here?

[PhilipA]

Er are you talking 38A here or RRC, as I am sure you know the outputs on a 38A are on the LHS not the right like a RRC.( for LT230)
I have an RRC BW input jackshaft here, which I THINK would be the same as a 38A anyway.
Let me know if those dimensions are a help

Regards Philip A

[paradigm]

Hello Philip I am asking for a 38a , but all I really need to know is , if the jack shafts are the same. does anyone have a photo the back end of a zf24 , by any chance?

[benji]

Sorry I don't have any photos or measurements, but an LT230Q in a p38 would be a great thing if that's where your heading.

[paradigm]

Sorry I don't have any photos or measurements, but an LT230Q in a p38 would be a great thing if that's where your heading.

is a lt230q left or right drop ?

[PhilipA]

is a lt230q left or right drop ?

That is why I asked. AFAIK all LT 230 have driveshafts on the right, while the BW is basicallyy the same RRC to 38A but clocked, plus the electric selector.
There is no way that an LT230 could be clocked AFAIK as this would put the selectors on the bottom , no sump etc etc.

Regards Philip A

[paradigm]

I will make a new short shaft that will fit my tc. I think

[paradigm]

I want to mate a t56 viper transmission with a borg warner tc. Via adaptor plate .
Its been installed on a lt230 before. That is why I asked about the input shafts