Llams install Perth

[LR D4]

Could anyone recommend, where I could get Llams fitted here in Perth??

[Tombie]

Your driveway... :)

Its very, very easy to do.

Theres several how-to's, photos etc, and Graeme provides excellent phone support...

[~Rich~]

Easy as long as you are a bit of a contorsionist!

Loom: https://www.box.com/shared/zzgi1qs5rt

Switch: https://www.box.com/s/t6moiqqurkyaiq5oz67t

[Graeme]

Make sure the grey plug that fits in the ecu is properly seated as its a little stiff to fit these days but easy to feel that its OK. Stash the grey joining connectors amongst other nearby wiring so they can't bounce around and pull on the connector.

[DoctorJ]

Easy as long as you are a bit of a contorsionist!


So true,but it is easy!

Cheers
Julian

[discotwinturbo]

Yep.....easy.

I am in Perth.....Orange Grove, if you need a hand.

Brett....

[LR D4]

Thanks Gents!!

You guys give me the confidence to do these kind of things, it's nice to know you always have the support of the Aulro guys behind you.

I will undertake the install, over the weekend and will let you know the outcome..

Cheers

[Graeme]

Can anyone recommend a business in Perth that would install a Llams kit into a 2011 RRS?

[Geedublya]

Osborne Park Autospark, seem to know their late model Landrovers.

[samandfee]

Hi Graeme.
I am happy to say I took Brett up on his offer(discotwinturbo) and he did an excellent job.

Cheers.[thumbsupbig]

[Simeon Prucha]

Easy as long as you are a bit of a contorsionist!

Loom: Box (https://www.box.com/shared/zzgi1qs5rt)

Switch: Box (https://www.box.com/s/t6moiqqurkyaiq5oz67t)


I can't seem to access / download the installation instructions. Just bought the kit and wanting to fit it to my 2015 LR4

[Mog60]

I can't seem to access / download the installation instructions. Just bought the kit and wanting to fit it to my 2015 LR4

Hope this helps,

[Simeon Prucha]

Than ks Mog60. I fitted it today to my LR4. Relatively easy but now getting suspension faults... :-(

[Mog60]

Did you disconnect the battery before fitting? If not you might expect to see some faults occur. From memory some have said these will go after cycling the ignition a few times.

The following comes from the instructions:-

Reconnect the battery and switch on the ignition. A suspension fault may be shown if the battery was not disconnected,
in which case switch the ignition off then on to clear the message. If a fault message is still displayed then refit all
connectors.

Hope it sorts itself.







.

[Graeme]

I've been in contact with Simeon regarding the faults. Something is amiss.

[Graeme]

One of the ICs in the LLAMS module was faulty in a manner that I've not seen before which wasn't spotted during module checking even though it would have been showing on the oscilloscope.