locker

[disco fox]

how do i get axle out drivers side in a maxi drive locker

[PhilipA]

Lock the difflock.
Regards Philip A

[disco fox]

tried that but still couldnt get it out trying to pull centre out so i can do pinion barring

[PhilipA]

54509

The above is the manual.
You have to take off the end cap, then remove the cap etc etc after locking the diff.
Then you have to remove the bearing spindle.

[TeamFA]

54509

The above is the manual.
You have to take off the end cap, then remove the cap etc etc after locking the diff.
Then you have to remove the bearing spindle.

G'day PhilipA! I don't suppose you could scan this in a higher resolution? Is there any more to this documentation?

We bought our 110 already fitted with Maxi-Drive axles and lockers front and rear, but no documentation. I haven't had to touch anything there yet, but it would be good to have some info when I do...

Thanks!

[PSI250]

G'day PhilipA! I don't suppose you could scan this in a higher resolution? Is there any more to this documentation?

We bought our 110 already fitted with Maxi-Drive axles and lockers front and rear, but no documentation. I haven't had to touch anything there yet, but it would be good to have some info when I do...

Thanks!

+1 for manual if possible?
always handy to have that kind of stuff floating about.

[PhilipA]

It would have scanned at higher resolution but would have been reduced for the forum.
I saved it as a JPG and used paint to rotate it and it is just readable.
If you send me your email addresses by PM , I can scan the whole thing and email it to you.
That is really the only page that deals with service, the rest is puff stuff on how to use the maxi.
Regards Philip A