View Full Version : Puma TC/ABS lights
scarry
27th December 2012, 05:42 PM
Had a txt from my son who is away on Fraser island,and the TC and ABS lights are on all the time.Turning engine off & on has not fixed the problem.
Got him to check all the ABS sensors are where they should be,that is haven't fallen out,and the wiring going to them is also OK.
Not really a biggy as it still goes OK,probably has no TC/ABS at the moment. 
Any ideas?
Faulty ABS sensor?
Done a few searches on here can't find much about this  issue.
Allan
27th December 2012, 05:46 PM
Could be the fuse,  could be worth a look.
Allan
geckos
27th December 2012, 09:07 PM
Had this on my 2005 def 110 with ABS. Check the earth piont. (bolt/nut loose). I hit myself after this, so simple!
scarry
27th December 2012, 09:12 PM
Had this on my 2005 def 110 with ABS. Check the earth piont. (bolt/nut loose). I hit myself after this, so simple!
Is it under the passenger seat where the battery is?If not where is it?
Thanks.
dmdigital
27th December 2012, 09:22 PM
Main earth is to the chassis rail below the battery box under the passenger seat. Also check the wiring connections in the box under the drivers seat as well as the fuses.
jimr1
28th December 2012, 01:46 AM
:) hi hi iv'e had tc abs lights come after comming down a long hill in the high country, plus hill decent even though it wasn't in hill decent. this was on my disco 2. its called the 3 amegos .a mate has a hand held code reader , he went through the codes and swiched them off .then i changed my rear rotors on my 110 , and yes abs tc lights .back to code reader abs sencer not close enough to rotor pushed it in further .reset code lights off . now i don't why yours have come on ,but if you can get access to a code reader it will tell were the problem is good kuck ;)
Rick Fischer
28th December 2012, 03:51 PM
ABS earth from 09MY is on gearbox.  Problems with the body earth on earlier iterations I guess.  
Cheers 
RF
SloMoBro
28th December 2012, 10:08 PM
We had a similar problem on our puma and found the earth on the gearbox was loose also. Tightened it up and haven't had a problem since.
Powered by vBulletin® Version 4.2.4 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.