Programming key plip as a SLS remote

[petmic]

I am wondering if a key plip for Disco 2 can be programmed as a SLS remote plip using nanocom? Has anyone tried that?

I bought a key plip of ebay, entered the 6 digit code from the sticker on the chip inside to BCU-SUSP using nanocom. I did resync the key, the plip is detected correctly as SUSP (using "key detect" in nanocom). Everything seems ok except the plip is not raising/lowering the back of the car. It is locking/unlocking the car as it was programmed as a normal key plip. Any ideas?

[petmic]

I tried to do RF test in nanocom. It says "Key Susp signal was detected". Why is it still locking/unlocking doors?

[SiddersC]

It will not work, I also tried this

You will need the correct SLS remote

[Pedro_The_Swift]

Bloody Bavarians!:mad:

[Infiltrator]

Are these the right ones for Australia?

STC50143 (Other markets except Japan)

STC50143 | eBay (http://www.ebay.com.au/dsc/i.html?LH_TitleDesc=1&_sacat=0&_from=R40&_nkw=STC50143&LH_PrefLoc=2&_trksid=p2045573.m570.l1313&_odkw=STC50075&_osacat=0)


or this one
STC50075 (UK and European models)

Or this one? ( I highly doubt this one....)
STC50146 (Japanese models)

[petmic]

STC50075 is 433MHz
STC50143 is 315MHz

I believe that Disco's in AU use 433MHz, same as in the UK and EU.

STC50075 should be the one you need.




Are these the right ones for Australia?

STC50143 (Other markets except Japan)

STC50143 | eBay (http://www.ebay.com.au/dsc/i.html?LH_TitleDesc=1&_sacat=0&_from=R40&_nkw=STC50143&LH_PrefLoc=2&_trksid=p2045573.m570.l1313&_odkw=STC50075&_osacat=0)


or this one
STC50075 (UK and European models)

Or this one? ( I highly doubt this one....)
STC50146 (Japanese models)