"Sunroof not set"

[rc42]

I had the battery disconnected for some welding work a couple of weeks ago and since re-connecting I got the usual 'window not set' message for all four windows which was fixed by fully lowering and then fully raising each of them, one at a time. However, the 'sunroof not set' just won't go away after multiple attempts at fully opening and closing as well as the raising and lowering, does anyone know if there is a special trick to resetting this message?
I have a Nanocom Evo II if there's anywhere amongst its menus and options that this can be forcibly reset.

Any advice would be greatly appreciated.

[Craig_Keira]

Pretty sure you have to slide it back and hold the button down until you get a beep from the dash? I've done this a couple if times without issue. Give that a go.

[Scouse]

It needs to go all the way back, then closed, then tilt up & finally tilt down before it will set.