Thermostat housing plug thread

[Brad110]

I am trying to ascertain the thread so I can purchase a reducing nipple to accept a temp sender.

The thread is parallel.

[russellrovers]

I am trying to ascertain the thread so I can purchase a reducing nipple to accept a temp sender.

The thread is parallel.
hi i will look in my goody box and see what i can find jim

[andy_d110]

I am trying to ascertain the thread so I can purchase a reducing nipple to accept a temp sender.

The thread is parallel.

Give Chazza a pm as he reproduces these housings so he may have the adaptors you need or know the thread size.

[mfc]

I'd check that it isn't a standard local pipe thred , I recon most of em have just been drilled and tap'd locally ... ....

[Brad110]

Trying to source bushes for brake pedal pivot and the 2 clutch pivot bushes.

Has anyone fabricated spares?

[Defender Mike]

Im after the same if you find em:)

[chazza]

I use a 1/2" BSP thread when I make the housing; this allows a 1/2" valve from the local hardware store to be used as the control for the heater.

For my 80" I used pedal bushes from the UK. They will need reaming once they are installed; I used an expandable reamer I bought on eBay.

Google the part number for the bush for your car and you should get some hits - I can't remember where I bought mine from,

Cheers Charlie

[gromit]

If you press the bush out and take to a bearing supplier (or just take the dimensions) they should be able to source something similar.


Colin

[mfc]

I am trying to ascertain the thread so I can purchase a reducing nipple to accept a temp sender.

The thread is parallel.

I drilled and taped my housing for a unf fitting from supercrap then picked the adaprpter to suit the gauge( non l rover gauge though)... Easy as on an aloy housing... With the cast it needed a good soak in molasis to get the rust scale off
Holdens in the uk have the correct threaded peices for water/ oil pressure gauges as well as the pip pressure t peice( a bit over a weeks delivery but there site ill give you the thread and size)

[Charlie's brother]

Hi Guys

Paddocks have the clutch and brake pedal shaft bushes

Cheers Nick