moved to tech section

[Jojo]

No, to the best of my knowledge there isn't. But don't worry as this is a very straightforward procedure:
1. take wheel off
2. remove clips, springs and retainers
3. remove brake pads
4. open brake fluid reservoir (to release pressure)
5. find suitable tool
6. lever in brake cylinder pistons
7. close reservoir
8. apply some copper grease
9. fit pads, clips and sundries, etc and wheel
10. wash hands
11. drive off

Good luck!

[one_iota]

Jojo

Disc pad change leit gemacht. (forgive my school german)! style_emoticons/<#EMO_DIR#>/laugh.gif

[Jojo]

Moin Mahn,
das hast Du schön gesagt!! style_emoticons/<#EMO_DIR#>/smile.gif style_emoticons/<#EMO_DIR#>/smile.gif
Your German is really good, just wait until we can meet and you'll have plenty of opportunity to practice :wink:
Tschüß

[landrovermick]

WOuldnt this post be better served in the " techincal section "

BB can you move it ?

Mick

[bigbugga]

Originally posted by landrovermick
WOuldnt this post be better served in the " techincal section "

BB can you move it ?

Mick

Would if i could, Incisor has power in this area.

[KEV0044]

...

[bigbugga]

Moved the post but the original question didnt move with it.
This is the first post I have had to move so one mistake isnt too bad is it.

So here is the original question.

BigMark
Joined: Apr 07, 2004
Posts: 3

Posted: Wed Apr 07, 2004 3:38 pm Post subject: 96 Disco brake pad change

--------------------------------------------------------------------------------

Hi
Is there a way of changing the front disc pads without releasing the fluid pressure on the wheel cylinders or is this not a recommended practice