2002 def 110 td5 fuel pump

[Obi]

I have been advised the pump is embedded in the top of the fuel tank and it is advised to cut an access hole in the floor. If any one could advise the co-odinates and hole size it would be appreciated. Also would cutting a support or stiffener be required. I have read that a hole in the floor only enables checking the pump and does not enable it to be replaced, is this correct.
Cheers Obi

[gromit]

This comes with install instructions :-
Mulgo Fuel Pump Inspection Panel - Defender Td5 | Buy 4x4 Land Rover Toyota Nissan Accessories and Parts Online Store | Expedition Centre Australia by Mulgo (http://www.expeditioncentre.com.au/online-store/land-rover/defender/mulgo-fuel-pump-inspection-panel-defender-td5.html)


Colin

[eddy]

Measurements are listed in other threads on this subject.I seem to recollect the Discovery TD5 pump is the same as the Defender but cheaper, only requires changing the float arm over.