View Full Version : 4bd1t injecter pump boost diaphragm
izu
5th December 2014, 11:30 AM
My injector pump has a diaphragm to deliver more fuel under boost,can i replace it without removing the pump.
would appreciate any advice.Phil
Ancient Mariner
5th December 2014, 12:43 PM
Abit of good timing if the same as 4he1t just pulled it apart a 10mm nut and
slot in shaft about middle in pic so I would say no :(
Dougal
5th December 2014, 05:11 PM
Yep, whole boost compensator housing unbolts and pulls off. Just be careful with the pushrod inside.
izu
8th December 2014, 06:44 PM
Thanks for help, it was just the gasket holding on, i taped a kitchen knife carefully down into the gasket and the housing popped off, there was 2 small holes in the diaphragm, hopefully that is where i am losing power! Rang looking for new diaphragm $50 plus $10 for gasket.
Powered by vBulletin® Version 4.2.4 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.