zzsteve
12th February 2015, 12:37 PM
Noticing some bearing noise in the alternator and charging voltage barely getting to 14V @ 1800RPM on a charged, new battery with no extra loads on.This may be contributing to episodic GEARBOX FAULT on the message centre and failure to progress sometimes.
So, I am looking at the Bosch alternator I just pulled out of the VY Commodore and not seeing too many obstacles to a swap.
Before I do a trial fit:
a) Is there any other preferred swap in a GEMS engine (given the price and reliability of the MM)?
b) I heard rumourings that the set point on a MM in the GEMS is only 14V anyway - sounds too low to me.
c) Do I chase bearings, brushes and regulator, and fix up the Marelli?
TIA
Steve
So, I am looking at the Bosch alternator I just pulled out of the VY Commodore and not seeing too many obstacles to a swap.
Before I do a trial fit:
a) Is there any other preferred swap in a GEMS engine (given the price and reliability of the MM)?
b) I heard rumourings that the set point on a MM in the GEMS is only 14V anyway - sounds too low to me.
c) Do I chase bearings, brushes and regulator, and fix up the Marelli?
TIA
Steve