Clutch

[mick88]

Can anyone tell me what clutch plate and pressure plate are used in a "Johnson" Holden conversion on a series 3?


Cheers, Mick.

[Blknight.aus]

it can go either way, it depends on if the flywheel was drilled to take the landy plate or if it wa left on the holden plats (the spline count/size is the same.

most of the ones I've done clutch changes on have used the landy clutch to suit the engine that was originally in there.

[mick88]

it can go either way, it depends on if the flywheel was drilled to take the landy plate or if it wa left on the holden plats (the spline count/size is the same.

most of the ones I've done clutch changes on have used the landy clutch to suit the engine that was originally in there.





Thanks Dave,
not sure what you mean by the spline count/size is the same though!


Cheers, Mick

[Blknight.aus]

the spline count and size of the friction plate for a holden and landrover of comparable vintage is the same.

im having a mental block ATM but I remember that as a get you out of trouble fix one of the friction plates has a smaller OD than the rest and if you were in a bind you could use that one with any of the landy engines or any of the holden fours or 6's of the era...

you may not quote me on this but instinct wants me to think it was the friction plate out of the clutch from the earlier low compression II/IIA 2.25