Some Movement at the Station

[Lionelgee]

Hello Holden Series People,

I spent some time removing the 137 cc Holden carburettor and inlet manifold that was installed on Rebus when I bought the vehicle. It is a 202 red motor out of a HQ, according to the engine number. It now has most of the new manifold and re-manufactured carburettor for a 202 bolted up. I just have to sort out the linkages and pipes tomorrow.

I also have a new Bosch-clone electronic ignition system to install.

Cross fingers that it all works out as it is my first foray into electronic ignition installation!

Kind Regards
Lionel

[mick88]

Sounds good Lionel.
It will run like a singer sewing machine when you fire her up!

Cheers, Mick.

[Lionelgee]

I spent some time removing the 137 cc

Hello All,

I just checked off against a Stromberg Manual and Rebus was fitted with a 161 ci carburettor - not a 137.

Kind Regards
Lionel

[mick88]

Hello All,

I just checked off against a Stromberg Manual and Rebus was fitted with a 161 ci carburettor - not a 137.

Kind Regards
Lionel

Lionel you probably mean a 173 ci as Holden didn't make a 137.
The nearest to 137 ci was the little 2225 cc or 138 ci and also the grey motor 138.

Cheers, Mick.

[Lionelgee]

Lionel you probably mean a 173 ci as Holden didn't make a 137.
The nearest to 137 ci was the little 2225 cc or 138 ci and also the grey motor 138.

Cheers, Mick.


My Bad Mick :) I think I will get back to my PhD where I know what I am writing about and leave things Land Rover alone for a while.

Kind Regards
Lionel