iPad/GPS Mount

[Witchdoctor]

Just put together a mount for my GPS.

I used the rearview mirror location as i cannot see out of the back of my 90 anyway. The mirror is removed as well as the 3 screws that hold the mirror mount in place. I purchased a block of 25mm alloy & tapped a M10 thread in the centre of it & the 3 holes to re mount.
I purchased
3 x 1" RAM balls with the M10 threads on each end.
2 x 1" RAM short arm clamps
1 x iPad mount.
I also used a piece of 16mm alloy rod with the M10 threads in each end.
Now i need to paint it all low sheen black.

Cheers
David

[steveG]

Looks great.
Instead of paint, what about a long piece of black heat-shrink over the shiny bits?

Steve

[Chops]

Now that's a magic spot to have it. I was going to use the Ram mount system from the passengers side floor/tunnel, but still kinda looks like it'd be in the way. Your idea fits the bill nicely, and I'm guessing if it turns out to be a bit low or higher that what you'd like, just shorten or replace the rod.
How has it stood up to bumps and corrigations etc, tested it yet?

[DiscoMick]

You may want to check if not having an internal mirror counts as a defect and could void your insurance. Pretty sure ADRs require a mirror, but I could be wrong.

Sent from my GT-P5210 using AULRO mobile app

[Chops]

Mick, I'm pretty sure when the rear screen is blocked or covered, either from inside or outside, in a permanent fashion, it's ok.
I have been known to be wrong though :D

[Witchdoctor]

steveG,
Great idea, i will use it thanks

Chops,
I have not had it out off road as yet, but it will be getting a good test in a month on Fraser. If i was to do it again i would but the next size up RAM ball or look for an all metallic balls as the 1" balls are rubber & you do get a little flex. That said a little movement is a good thing stops things from cracking.

Disco Mick,
The rear of the truck has no posable way of seeing out the back as it is full of draws & stuff. So no real point of a rear view mirror in my 90
Ill run the risk:p

Just checked with a QLD engineer, as long as there are both side mirrors I'm sweet.

David