Log in

View Full Version : LLAMS for L405/L494


Graeme
21st September 2015, 07:22 AM
Advance notice that LLAMS kits will be available for these vehicles within about 3 months. A bespoke mating connector for the original loom connectors has been produced and tested. Original manufacturer connectors will be used to connect to the dynamic suspension module. A module has been trialled in a 2014 RRS for over a year without any adverse effects.

Medium raised will be the same 35mm as OR1 and high raised 50/55mm. A 3m switch lead will be provided due to the suspension module being located in the right rear corner of the vehicle. Installation (or removal) of the wiring harness and module will be very quick but running the switch lead to the front or centre console will undoubtedly take longer.
Graeme
20th November 2015, 08:32 PM
Still a couple of months away but these arrived today, to be sent to the factory that will make the looms. They are OEM connectors and will plug into the suspension module in place of the original connectors.
https://www.aulro.com/afvb/images/imported/2015/11/345.jpg
Graeme
9th March 2016, 06:42 PM
Not far off now, with the looms having arrived today and final height checking shortly.
Graeme
9th April 2016, 10:15 PM
Time gets away quickly but now expecting the final programming tweaks to be validated later this week.
Graeme
30th April 2016, 09:40 AM
L494 kit development is complete and kits will be available within 1 week.

L494 brochure
108718

L494 fitting instructions
108719

For the L405 I need a volunteer to test fit, take a few pictures and check height calibrations in exchange for a kit. PM me if interested.
Graeme
29th December 2016, 08:27 PM
For the L405 I need a volunteer to test fit, take a few pictures and check height calibrations in exchange for a kit. PM me if interested.Just a bump in case there's an L405 owner who would like to take up the offer. I don't know about the L405 but my L322 certainly benefits from some extra bump-stop clearance when travelling quickly on gravel tracks and roads.
Graeme
7th January 2017, 06:55 AM
This kit now provides a calibration option to make the high setting full OR2 height (65 mm) instead of 55 mm (75 mm instead of 60 mm for the L405). Original version modules can be returned to have the s/w upgraded.