front diff drive spigot torque setting

[worane]

Can any one please tell me the torque to set the center bolt at that comes out of the front diff to prop shaft.
I have just replaced the weeping oil seal and I know it was plenty tight when getting it undone. I know it has locktite on it but the correct torque must be vital I would think. My RAVS is not talking to me today, Just won't open.
Thanks in advance for any help.
Regards, Nick.

[kelvo]

100Nm

http://www.aulro.com/afvb/attachment.php?attachmentid=106642&stc=1&d=1457317946

[worane]

Thanks Kelvo for the prompt reply I think it is the 360 ft ibs setting I am looking at.
My torque bar only goes to something like 180 ft lbs. I guess it is a matter of hitting that rating and then going some more! Plus loctite

[discorevy]

Hi Nick
360 ft/lbs is the driveshaft nut , for the wheel hub

[worane]

Thanks Disco. Hope you are well.