Sorting out OBDII input for omvl dream

[DieSchnelleKafer]

Hi Folks. another question that i need answered!

im in the depth of splicing the omvl dream xxi wiring loom into the D2a's loom. all is well and good, but i have gotten stuck in regards to the wiring of the OBDII. On page 8 of the following link you will instructions on how to wire the omvl ecm into the obd port connections:

https://dl.dropboxusercontent.com/u/31594560/ECU%20Manuals/Digitronic%20AEB%202568D%205%206%208%20cyl.pdf


It explains that there is 2 different types of combinations that can be made depending on what type of canbus signal your car has. Without the proper tool to asses what canbus i have on my 2004 discovery, it is impossible to know which combination of wiring i need to carry out. can anybody guide me as to which way to wire this in?
Thanks in advance.

[bee utey]

Not all pins will be present in your obd2 port. Either one connection, or the other, or neither will be present. I have not seen a port where both 6 and 7 were present. In any case, it's not a very important function, it will run perfectly well without it.

[DieSchnelleKafer]

Not all pins will be present in your obd2 port. Either one connection, or the other, or neither will be present. I have not seen a port where both 6 and 7 were present. In any case, it's not a very important function, it will run perfectly well without it.

Okay thanks. I might just skip it then and cap the wires.