PDA

View Full Version : Puma interior - top door seal, seat recline handle and door lock knob surround


twr7cx
27th January 2017, 10:14 AM
I am going around and fixing up some of the minor imperfections on our 2011 Puma 90. Have a few dodgy bits in the interior which I'm seeking a bit of advise on:

1. The passenger side door lock knob surround slides upwards. It can be pushed back down but fairly quickly will be back up following a few door unlocks and locks. Any reason I can't put a dab of glue to help secure it in it's correct place?

https://www.aulro.com/afvb/images/imported/2017/01/199.jpg


2. The drivers side top door seal keeps drooping down. Can be pushed back up to it's correct place but within a few door openings and closings it will be back hanging. Any reason I can't put a dab of glue to help secure it in it's correct place?

https://www.aulro.com/afvb/images/imported/2017/01/200.jpg


3. When I got the vehicle the recline knobs were missing on both the front seats. I have purchased and fitted replacements, but are these a common item to knock off? Any reason I can't put a dab of glue to help secure it in it's correct place?

https://www.aulro.com/afvb/images/imported/2017/01/201.jpg
https://www.aulro.com/afvb/images/imported/2017/01/202.jpg
Tombie
27th January 2017, 10:16 AM
Forget glue. Silicone [emoji41]
twr7cx
27th January 2017, 10:17 AM
Forget glue. Silicone [emoji41]

Sikaflex style?
Tombie
27th January 2017, 10:52 AM
Sika you'll never get apart if required..

Neutral cure silicone will do just fine
Col 110
27th January 2017, 12:20 PM
Mine has this issue with the rear passenger door lock knob surround sliding upwards - when I took it in for the first service I pointed out that the door trim (on that door) was not attached to the door correctly and they are 'ordering parts' to fix it - my assumption this will also fix the door lock surround - albeit this is not a issue that bothers me too much.

https://www.aulro.com/afvb/images/imported/2017/01/197.jpg




1. The passenger side door lock knob surround slides upwards. It can be pushed back down but fairly quickly will be back up following a few door unlocks and locks. Any reason I can't put a dab of glue to help secure it in it's correct place?