My current project

[hodgo]

A good mate owns a 1 tonne tray back and asked me to convert it to a tipper after much research we found a basic kit designed for falcon and commodores mainly Its been an interesting challenge making it fit and keeping it capable of operating safely when loaded to max. Tomorrow I make and fit the brackets to hold the Hyd power unit and wire it up. Then mod the tray to fit kit

[Tombie]

What's with the hydraulic set up?
Doesn't look phased or balanced in any way...

Keep an eye on it [emoji6]

[cjc_td5]

Are the rams parallel to the tray (ie horizontal) when fully down? If so, the tray is going to need a big helping lift to get started as there is little mechanical advantage when fully lowered. They will want to push the tray forward rather than up...

[hodgo]

Are the rams parallel to the tray (ie horizontal) when fully down? If so, the tray is going to need a big helping lift to get started as there is little mechanical advantage when fully lowered. They will want to push the tray forward rather than up...

This was a concern of mine when I first saw the kit but I am assured that there is enough off set to allow the lift by the manufactures