td5 a few questions re nanocom readings and accelerator pedal.

[Bazzle218]

2000 td5 disco. Issue slow off the mark unless i slip clutch. Nanocom reading accelerator pedal, Supply: 4.933, input 1 .581 . input 2 4.481. One and two read 0.129 v over input ????

pedal depressed fully Supply 4.993 -5.000 input 1, 3.653 input 2, 1.572 added , 5.225V over by 0.223v. Would you say accelerator pedal fault ????

interestingly from what I have read a 2000 td5 has a two wire accelerator pedal. The nanocom also shows a reading on number 3 input as 9.99 volts . Why is this so ? if its a two wire joby.

Only fault showing is egr stuck closed. As it has been removed by previous owner, will this code cause an issue, like a limp mode. Thanks Baz

[sierrafery]

Hi, IMO nothing is wrong with the TPS albeit it's not normal that the sum of the two tracks to be higher than the supply it might be just some ADC calculation error cos that's a potentiometer which reduces voltages it can't amplify them, read the whole data log eventually record inputs fuelling and post them here... maybe you have a naughty MAF or something, take a drive test with it unplugged and if it's better then you need a new one