Chassis paint recommendations ?

[JohnboyLandy]

Hi All,

I started to paint my chassis with Septone "Chassis Black" paint, I've only done the cross member so far, but I was wondering if this stuff is any good, or whether anyone else has better recommendation.

This paint has a gloss finish, which I am not too keen on.

Any suggestions / comments welcome.

Thanks
John

[gromit]

I'm sure you'll get a lot of differing opinions.
I haven't painted a complete chassis only axles & parts of chassis', my latest paint of choice is a Dulux epoxy enamel that you can buy in Bunnings. I brush paint but 'stipple' rather than brush normally. This gives a finish closer to spray painting without brush marks but is hard on brushes (it has to be bristle not synthetic).
The paint comes in matt, satin & gloss.

I've also use White Knight epoxy enamel and a few other brands. All were OK.

POR15 is used by many but be aware that it fades in sunlight. Apparently it gives a high gloss level surface.
You can also achieve this by adding Penetrol to your paint.

A 2-pac would be ideal and very tough but I'm certainly not set up to spray it and I'm often doing small parts here & there so there would be a lot of wastage.

Colin