MarkM
23rd December 2017, 01:51 PM
Hi All,
Today, I had a problem....
After I had driven the landy for 5 mins, stopped and restored, came up with engine warning light and the TCS(?) warning light. These stayed on for the next 3 or 4 short trips in the car, 1/2 an hour or so, then have gone out.
Once I got home connected Nanocom, only 3 "tested" faults showing, 2 were invalid data and 1 was throttle position fault. Don't think these are related to the issue. Too many "untested" faults for the Nanocom to load. Was expecting to see a wheel sensor fault, did not see this.
Any ideas?
Mark
Today, I had a problem....
After I had driven the landy for 5 mins, stopped and restored, came up with engine warning light and the TCS(?) warning light. These stayed on for the next 3 or 4 short trips in the car, 1/2 an hour or so, then have gone out.
Once I got home connected Nanocom, only 3 "tested" faults showing, 2 were invalid data and 1 was throttle position fault. Don't think these are related to the issue. Too many "untested" faults for the Nanocom to load. Was expecting to see a wheel sensor fault, did not see this.
Any ideas?
Mark