PDA

View Full Version : Whoop whoop whoop noise at 55kmh



karlz
14th April 2018, 05:03 PM
This noise has been bothering me for the last 4 months.
I'm not sure whats causing it, but I still have another 4 months warranty and it goes to the dealer in 2 weeks.

The sound very slowly increases in intensity from about 40 and peaks at about 55-60, it seems to disappear after 70.
Sound is present regardless of gear, and is also present in neutral.

Its a whoop whoop whoop sound.

Im thinking prop shaft or universals.

Anyone else had this, its really annoying me now that even my wife notices it now.

Mick_Marsh
14th April 2018, 06:00 PM
I'd be thinking tyres.

Naks
14th April 2018, 06:18 PM
Buckled rim

DeanoH
14th April 2018, 07:10 PM
Whoop whoop whoop noise at 55kmh


Try moving over to let the police car pass ! :)

Deano :)

bee utey
14th April 2018, 07:56 PM
Could be an oil seal on a wheel hub installed off true and slightly dry.

67hardtop
15th April 2018, 02:58 AM
Tyre noise. check for scalloped or lumpy tread.

trout1105
15th April 2018, 04:52 AM
I'd be thinking tyres.

+1

ATH
15th April 2018, 06:25 PM
We had a noise which called have been described as "whoop whoop" on our 300TdI Deafener some years ago. No one could diagnose where it came from or what it was but after searching on here I slackened off the belts, removed them from the crankshaft pulley and found that had some slack when pushing and pulling it.
Following a recommendation from someone I took it to a clown in Osborne Park who brutalised with a chisel the nut holding the fan on (but that's another story) but changed the pulley as the keyway was worn.
End result apart from much nastiness about his or his workers ability was no noise. Check that first would be my advice.
AlanH.

DrytheRain
24th April 2018, 11:14 PM
Someone correct me if I’m wrong, but a dealer technician told me that noise was caused by the transfer case input shaft. He described it as a ‘characteristic’, but I’ve always been concerned it was a sign of imminent failure after reading on here about stripped input shafts. That said, we have two Defenders in our household and both have been making that noise for three or four years and still work...

gromit
25th April 2018, 06:30 PM
I have a similar noise (from your description) on a modern Ford.
Crawled underneath looking for something loose & flapping but nothing.

Into the service department and after a quick test drive it was diagnosed as wheel bearing on the way out.


Colin

karlz
30th April 2018, 08:20 PM
Into the service department and after a quick test drive it was diagnosed as wheel bearing on the way out.


Colin

Yeah Im thinking the same, I dont reckon my noise is a tyre.

JDNSW
1st May 2018, 06:05 AM
I agree with Colin. Check temperature of the hubs after driving a few kilometres.

gromit
5th May 2018, 08:05 AM
I did several thousand Kms with the noise getting slightly worse (dealer couldn't book me in). I did notice the noise changed a bit on cornering.
On the Territory they change the complete hub assembly, I asked if I could have a look (they have to keep it for a period of time because it was done under warranty). Bearings 'felt' OK but because they were still in the hub I couldn't see the mode of failure.

All nice & quiet again now !


Colin

karlz
31st May 2018, 05:16 PM
Well I got the car back from the dealers 40k service today and they have confirmed its "likely" to be the tyre that's causing the noise.
They said the diff, wheel bearings etc are all good.

justinc
31st May 2018, 07:20 PM
I would also be checking wheel bearings again.... second opinion etc...

Jc

karlz
8th June 2018, 09:57 PM
Went to tyre place today, had the tyres rotated, balanced and alignment, Noise is now gone!!! noise has gone to woop woop