Rear seats 110 vs 130

[Ranga]

I understand 110 fittings are different to a 130, but are actual seats the same? i.e. can you swap the fittings from 110 rear seats to 130 fittings?

[TexDefender]

Just following up on Ranga's question. I did a bit of digging and it does seem possible if you have the correct mounts.

There was also a good write up on the defender source for upgrading the low-back seats to the Puma versions:
Puma 2nd row seats in older Defender - Defender Source (https://www.defendersource.com/forum/f6/puma-2nd-row-seats-in-older-defender-65742.html)

Ol' mate pointed out a few good points:

Ensure that the chassis brackets (P/N AQR710290) are installed underneath the tub in order to bolt down the seat mounting brackets. The chassis brackets should be the same between a 110 and 130.
The seat mounting brackets are different between the 110 and 130 as seen from the parts list in the first image. The 110 version comes as a single piece as seen from item #2, where as the part list for the 130 is a two piece set-up.
From all indications, the pivot brackets in the second image have slightly different numbers but britcar and lrdirect show HTM500180 as both 110/130


150695150696

[TexDefender]

Would anyone with a Puma 130 be able to send me a few pictured of bracket set-up under the second row seats in their 130?

I want to get an idea of the difference between the Puma 110 and Puma 130 rear seat brackets.

Tex