Defender Cargo Barrier

[Tyrepower]

I'm needing to get a Cargo Barrier for the Defender and want to know what's the go in your humble opinions. So
1: Who has what?
2: Where from?
3: How much?
4: How easy was it to instal?

Cheers Tyrepower.

[CraigE]

I have a Milford barrier. It is reasonably easy to fit yourself. Just takes a little time as it is fiddly with the trim. If you allow 6hrs at a slow easy going pace it should be fine.

[rangieman]

mine is a milford , unknown how much or where from cause it came with my bub https://www.aulro.com/afvb/

[numpty]

I have two in my Stage 1, both made by me. One goes behind rear seat, and if I remove rear seat, this one comes out and the other fits behind front seats from floor to roof. Bit fiddly to make if you follow the contours and curves, but not difficult. Naturally it doesn't conform to any design standards, but then it is only to stop what I carry in the back.
Perry.

[ATH]

I got mine from these people. Cost around $400 for a Milford and he came to my place to fit it. Very convenient.
Russell at ARB Osbourne Park recommended him and he didn't do a bad job.
Cheers.
AlanH

Addabar
47 Sugarwood Drv Thornlie 6108 (08) 9256 1510
Mobile Service 0409 298 249

[Greylandy]

Mine is an Ausguard bought from Opposite Lock in Brookvale (NSW) They are cheaper than Milford but built to the same standards. I had mine fitted at Opposite Lock and it all came in at under $400.

http://www.greylandy.com/images/cargo2.jpg

[Frenchie]

Yup Milford, Opposite Lock, less than $400 but that was 4 years ago. 8)

[Captain_Rightfoot]

Mine was Milford... apparenty there was some substantial confusion about some minor differences in the 05 models, and fitting between the child restraint and the seat... probably neither are issues you have to worry about...