drivesafe
6th May 2006, 07:20 AM
Hi folks, at long, LONG last, after receiving quite a few requests for both a Headlight Wiring Upgrade Kit and a Driving Light Wiring Upgrade Kit, I have finally got my act together and have a new HEADLIGHT WIRING UPGRADE PROJECT and DRIVING LIGHT WIRING UPGRADE PROJECT posted.
The biggest single advantage of these new projects is that you will NOT need to workout which are the correct wires in the old loom as the new loom simply plugs into the existing 3 pin headlight plug ( H4 type ). This will not only save a lot of time but means you don’t really need all that much knowledge about vehicle electrics and you don’t have to first workout if the vehicle has positive or negative switched headlights.
There should also be no need for any soldering either.
The set up is designed to be a “ Plug-and-Play “ installation
The reason for posting the HEADLIGHT & DRIVING LIGHT WIRING UPGRADE PROJECTS ahead of having the kits ready is because the automotive chain stores BURSONS, have Philips Automotive Globes on special for this month ( MAY 06 ) at around 30% off and that makes these globes very competitive and as you may have gathered, I personally think the Philips globes are Superior to other brands. So if you are seriously thinking about doing an up grade and want to use the Philips globes, now is the time to buy.
More details will be posted in the Projects and Tutorials Section, over the next few days.
The full kits will be available by the end of the week and will contain just about everything you need to do a wiring upgrade.
The kits will have the Relay(s), all wire needed, crimp terminals, pre-wired H4 Headlight Plug, split tube, electrical tape, cable ties and even a crimp terminal tool which can also be used for cutting and stripping the wire.
Check out PROJECTS 2A & 3A, in the PROJECTS and TUTORIALS section.
Cheers.
The biggest single advantage of these new projects is that you will NOT need to workout which are the correct wires in the old loom as the new loom simply plugs into the existing 3 pin headlight plug ( H4 type ). This will not only save a lot of time but means you don’t really need all that much knowledge about vehicle electrics and you don’t have to first workout if the vehicle has positive or negative switched headlights.
There should also be no need for any soldering either.
The set up is designed to be a “ Plug-and-Play “ installation
The reason for posting the HEADLIGHT & DRIVING LIGHT WIRING UPGRADE PROJECTS ahead of having the kits ready is because the automotive chain stores BURSONS, have Philips Automotive Globes on special for this month ( MAY 06 ) at around 30% off and that makes these globes very competitive and as you may have gathered, I personally think the Philips globes are Superior to other brands. So if you are seriously thinking about doing an up grade and want to use the Philips globes, now is the time to buy.
More details will be posted in the Projects and Tutorials Section, over the next few days.
The full kits will be available by the end of the week and will contain just about everything you need to do a wiring upgrade.
The kits will have the Relay(s), all wire needed, crimp terminals, pre-wired H4 Headlight Plug, split tube, electrical tape, cable ties and even a crimp terminal tool which can also be used for cutting and stripping the wire.
Check out PROJECTS 2A & 3A, in the PROJECTS and TUTORIALS section.
Cheers.