PDA

View Full Version : Air con through vents


Wagsman
9th October 2019, 04:46 PM
Hi guys
I have a 2002 discovery 2 td5, which slightly got wet during the floods. I replaced the fan, as it was not working.
With new fan I am not getting enough air flow out of the vents. The fan is cranking a lot of air.
What could be the issue?
Are there blocked filters or some shut off gates not ooening?
Done a self test on dislay and all good.
Bazzle218
9th October 2019, 05:18 PM
Mate Your location shows as Bluewater, is that north of Townsville? If yes i can come and and have a look your call at no cost of course. I found td5 aircons finicky things like you need to be at operating temp for things to work right.



I have a 2002 discovery 2 td5, which slightly got wet during the floods. I replaced the fan, as it was not working.
With new fan I am not getting enough air flow out of the vents. The fan is cranking a lot of air.
What could be the issue?
Are there blocked filters or some shut off gates not ooening?
Done a self test on dislay and all good.[/QUOTE]
thai_tiger
9th October 2019, 07:21 PM
could be the blend flap motors have seized if the water got into them, just unclip the flap and work the motor it might just free it up.
4bee
9th October 2019, 07:44 PM
Of course you would have re-fitted the Blower Wheel the right way around & wired it so it runs in the correct direction?



Of course you would have.[biggrin]


Just sayin'.
V8Ian
9th October 2019, 10:23 PM
Of course you would have re-fitted the Blower Wheel the right way around & wired it so it runs in the correct direction?



Of course you would have.[biggrin]


Just sayin'.
My initial thought, too.
4bee
10th October 2019, 08:04 AM
Bloody hell 58i, don't tell me we actually agree on something?[biggrin]

Has happened, but not to me it hasn't, but I would say that wouldn't I.

Simple mistakes to make especially if one is under pressure (or the pump.)

The other cause could possibly be the wheel &/or ducts are chokkas with ****.
Wagsman
1st November 2019, 08:56 PM
Well i checked the movement of the blend servos and distribution servo. All moved. Whether the doors are opening is the question. Still no air in vents even if fan is cranking. I will check to see if it is upside down. I feel cool air at vents
When i use distribution switch to change location, there is no difference.
I will accept anyone to come around and have another set of eyes to have a look.
thai_tiger
1st November 2019, 11:29 PM
have a try of this

YouTube (https://www.youtube.com/watch?v=IJ7IV8dQPb8)